Rapid manual dividing tables, manual horizontal and vertical divining tables

TDVO MANUAL HORIZONTAL VERTICAL DIVIDING TABLE

Material

G26 CAST IRON UNI 5007

BREAKING LOAD: Rmin = 26
ELONGATION %: A% = 1

This dividing table has been specially designed to be positioned vertically but can also be positioned horizontally. Its compact and sturdy structure guarantees its stiffness and lack of vibrations during machining, which is indispensable to achieve high precision. The coupling of the surfaces and the inside diameter between the base and the revolving table, is obtained by lapping, while all faces are properly ground. The ring-gear and the worm are made of UNI18 NiCrMo5 casehardened, tempered, ground steel and move in an oil bath. The worm is mounted on double-acting, adjustable, radial, thrust bearings. The coupling clearance with the ring-gear can be adjusted radially. The table is fitted with a handwheel with zero-setting graduated ring divided into minutes of degrees (1 notch on the ring = 1 '). Upon request, indexing plates can be supplied which can replace the handwheel in order to carry out repetitive indexing operations according to the relevant schedules. The rotating table can be locked with two lateral screws. The table comes with an instruction and service manual.

N.B.: specifications and dimensions are not binding

H2* only on request

TYPE	A	B	C	D	E	F	G	H1	H2*	L	M	N	O	P	WEIGHT Kg
220	310	340	200	20	280	16H7	160	160	139	140	10H7	60	80H7	220	68
280	400	400	233	20	340	16H7	160	160	139	140	10H7	60	80H7	280	90
340	480	490	293	25	400	16H7	160	180	157	158	14H7	60	80H7	340	164
400	540	560	333	25	460	16H7	160	180	157	158	14H7	60	80H7	400	210

TYPE	KG.(1) WITH TAILSTOCK	REPEATABILITY PRECISION	DIVISION PRECISION	DIVISION RATIO	F (Nm)	P (N)	KG	KG.(1) WITHOUT TAILSTOCK
220	120	0÷5"	±9"	1:90	117	590	200	80
280	180	0÷5"	±9"	1:90	137	1000	250	120
340	240	0÷5"	±9"	1:120	172	1370	400	160
400	300	0÷5"	±9"	1:120	196	1765	500	200